2020 John Deere 3025E

2020 John Deere 3025E

• Standard four-wheel drive (4WD) for maximum traction

• Tightest turning radius in its horsepower class

• Hydro transmission with Twin Touch™ pedals for ease of use

• On-board diagnostics including Service Advisor

Features may include:

• Economical cast-in-block cylinder design for good cooling and long life

• Direct fuel injection

• Improves starting

• Injects fuel directly on top of pistons for more efficient combustion

• Develops more horsepower per liter (gallon) of fuel than indirect injection engines

• Aluminum alloy pistons are lightweight to reduce connecting rod bearing loads and provide good heat transfer characteristics

• Design permits tighter tolerances and neutralizes expansion of the piston, which reduces blow-by and noise from piston slap

• Top rings are higher on the piston and a thinner head gasket is used to greatly reduce the volume of unburned waste gases and increase combustion efficiency

• Timing gears and injector drive gears have a helical profile to reduce engine noise

• Auto-bleed fuel system

• There is no need to prime the system if the tractor runs out of fuel

• The system will self-prime the injection pump, lines, and injectors, providing fast fuel recovery for easier starting

• High-capacity lubrication system provides filtered oil, under pressure, to all engine bearings for long life

• Key start and shutoff eliminates fuel shutoff knob

• Electric solenoid shuts fuel supply off immediately when key is turned off, which replaces the need to pull a fuel shutoff lever like many older tractors

• Fuel filter with replaceable element

• Water separator with additional replaceable filter element

• See-through coolant recovery tank permits operator to check coolant level without removing radiator cap

• Dry-type air cleaner with safety element

• Dual element design for added engine protection

• Easy to service

• Hood can be easily opened without tools for full access to the engine

• Easy access to engine check and fill points on the right-hand side of the tractor by removing the side panels.

• The 3E Tractors are available with a two-range hydrostatic transmission (HST) incorporated in a die-cast aluminum transmission case. Fluid under pressure transmits engine power to the drive wheels via a closed-loop pump and motor arrangement. Infinite ground speeds allow the operator to match the speed of the tractor to the job.

• No clutching for fast and easy direction changes

• Twin Touch™ foot pedals for quick and easy forward/reverse operation